From there, enjoy easy wiring thanks to 10 AWG push terminals (14 AWG direct leads in the 6.5 and 8-inch models). Soon you'll be on your way to a dramatically enhanced listening experience.
As with any SoundQubed subwoofer, proper break-in is key to enjoying long life from your HDS2.2. Make sure you follow the steps to loosen up the suspension before pushing these subs to the limit. The HDS2 series uses a 2.5-inch diameter, four-layer, copper dual voice coil with a conical back plate for longer travel.
High-temperature adhesives and high quality coil wire guarantee reliable long-term performance and a healthy level of bass! The HDS2 series feature cast aluminum frames. This upgrade provides better heat sinking and increased excursion over stamped-steel baskets.A softer three-piece spider system achieves enhanced performance and lower tuning. An Extended Range of Motion (EROM) surround profile keeps your cone diameter as large as possible while allowing for long, controlled excursion. The EROM profile gives you more cone area, greater stiffness, and lower mass for more accurate coil signal response.
The HDS2 has a non-pressed, fiber added cone for maximum rigidity and long life. Available in Dual 2- and Dual 4-Ohm configuration. Diameter four-layer copper coil 2?
Cast frames instead of stamped frames. Vented back-plate for optimal cooling and less turbulence in the coil gap.
Stronger motors with bigger magnets and top plates. Wider and taller surround for increased excursion. Conical back plate to allow more voice coil travel.
Black electroplated top and bottom plates. Non-pressed, fiber-added cone for maximum rigidity. This item is in the category "Consumer Electronics\Vehicle Electronics & GPS\Car Audio\Car Subwoofers". The seller is "soundqubed" and is located in this country: US. This item can be shipped to United States.