The HDS3.2 1200W Subwoofer. The dual-magnet motor features a bumped T-yoke for greater travel and better heat resistance. Additionally, the vented, electroplated back plate gives heat a way out and decreases turbulence in the coil gap. The HDS3.2 series uses a 3-inch diameter, four-layer, copper dual voice coil with a conical back plate for long-distance travel. The HDS3.2 series feature cast aluminum frames.
This upgrade provides better heat sinking and increased excursion over stamped-steel baskets. A softer three-piece spider system achieves enhanced performance and lower tuning. As a result, the HDS3.2 has an F(s) of 28.26 Hz compared to 35 Hz for the HDS3.1. An Extended Range of Motion (EROM) surround profile keeps your cone diameter as large as possible while allowing for long, controlled excursion.The EROM profile gives you more cone area, greater stiffness, and lower mass for more accurate coil signal response. The HDS3.2 has a non-pressed, fiber added cone for maximum rigidity and long life. 1200 Watt RMS, 2400 Watts Peak (Burp Only). 3-inch diameter, four-layer copper coil. Available in Dual 2 and Dual 4 ohm configuration. Black EROM surround without stitching. Vented back-plate for optimal cooling and less turbulence in the coil gap.
Conical back plate to allow more voice coil travel. Black electroplated top and bottom plates.
Non-pressed, fiber added cone for maximum rigidity. This item is in the category "Consumer Electronics\Vehicle Electronics & GPS\Car Audio\Car Subwoofers". The seller is "soundqubed" and is located in this country: US. This item can be shipped to United States.